Taking the Water Housing Out of a Kenmore Elite Refrigerator
- 1). Unplug the refrigerator from the wall outlet.
- 2). Remove the drip tray from the bottom of the dispenser by pulling it straight away from the housing.
- 3). Remove the screws at the bottom of the front panel of the dispenser, which are visible with the drip tray removed.
- 4). Slide the front panel of the dispenser toward the top of the refrigerator to disengage the clips, and then pull it away from the front of the refrigerator.
- 5). Disconnect the wire connector from the rear of the cover, and then set the cover aside.
- 6). Remove the screws securing the dispenser control module, and then pull the module away from the door.
- 7). Disconnect the wire connector on the module to completely remove it from the refrigerator.