Torso

• 1). Place a gear in the back of the torso piece. The torso is a large, red piece shaped roughly like a chest.
  
  
• 2). Push a gray rod with a stopper through the gear, with the stopper inside the chest. Attach a thick gray connector piece to the back of the rod.
  
  
• 3). Stick a black double-connector with end stoppers through the top of the chest cavity, with the knob on the back. Repeat with another knob connector.
  
  
• 4). Insert two gears on the sides of the cavity, so they mesh with the rear gear.
  
  
• 5). Attach the front plate of the chest to the black connectors, covering up the gears.
  
  
• 6). Slide the hip piece into the bottom of the torso. The hip piece has two joint-knobs on the bottom, and three holes along the top. Attach the hip into the torso by sliding in two gray connector rods.
  
  
• 7). Attach two blue connectors to the rear-mounted stoppers.
  
  
• 8). Insert a two-stud connector into the top of the torso, and place a joint connector onto that rod, making the neck joint.
  
  
• 9). Attach the transparent face piece to the back of the head piece, then click the ball into the neck joint.
  
  
• 10
  
  Attach Vakama's mask to the front of the face.
  
  

Legs

• 1). Attach a joint connector to the top of a foot piece.
  
  
• 2). Click a red leg piece to the top, with the wider point toward the base of the foot.
  
  
• 3). Attach a double-joint connector to the top of the leg piece.
  
  
• 4). Insert a black connector between the two joint pieces, and connect the thigh guard to this rod. The thigh guard is a red rectangle that wraps partially around the leg.
  
  
• 5). Repeat the process to make a second leg, then attach both legs to the torso at the bottom.
  
  

Arms

• 1). Slide the end of a four-stud connector into a double-joint connector. Slide a thick gray stopper onto the rod, pushing it to the joint piece.
  
  
• 2). Click a red arm piece, which has two ball joints, into the bottom of the joint piece.
  
  
• 3). Attach a second joint piece to the bottom of the arm. Insert a blue connector into the end of the joint.
  
  
• 4). Repeat to make a second arm. Place both arms through the chest piece, into the gears you placed earlier.
  
  
• 5). Attach the Kanoka Disk launcher to one of the hands. When not in use, you can attach it to the two blue connectors on Vakama's back.